Preparation
Liberation and feed preparation
A gravity-recovery discussion starts after reviewing whether the valuable material can be suitably prepared for the intended separation stage.
Explore Gravity Recovery →Gold processing guide
Gravity Recovery Equipment Selection
Discuss jig, centrifugal concentrator and shaking table equipment in relation to liberation, particle condition and the complete gravity-recovery route.
Selection context
Start with the material and route
Particle condition
Particle size and classification
Particle condition and classification are considered before choosing a recovery direction.
Explore Jigs →Jig
Jig in gravity recovery
A jig is discussed with prepared feed, density differences, water conditions and the wider recovery objective.
Read Jig guidance →Concentrator
Centrifugal concentrator
A centrifugal concentrator can be considered within a gravity-recovery route, but final configuration requires project conditions and verified model data.
Explore the family →Shaking table
Shaking table selection
A shaking table is discussed with prepared slurry, deck direction and the intended concentration objective.
Read table guidance →Concentration
The complete route
Recovery equipment is reviewed alongside upstream preparation and downstream concentration handling, not as an isolated purchase.
Explore Gold Processing →No fixed recovery promise
Project conditions determine the direction
Recovery performance and configuration depend on the material, liberation, particle condition, water and operating context. This guide does not publish a fixed recovery rate or universal equipment match.
Read equipment-selection FAQ →Real equipment references
Recognize gravity recovery equipment
Use these photographs to identify equipment families before discussing test results, feed size and the intended recovery stage. Machine dimensions and operating conditions must be confirmed for the selected model.
Project requirements
Send Your Project Requirements
Share Country / City, Material / Ore, Feed Size, Required Capacity, Target Product / Size and Power Supply. Final model selection depends on the actual material and project conditions.